333 words
2 minutes
Accessing My Home Network with Surge Ponte

What Is Surge Ponte#

Surge Ponte is a private mesh networking feature built into Surge. It establishes encrypted tunnels between your devices, so even when you’re away from home you can reach things on your LAN — your NAS, the router admin page, Home Assistant, and so on — just as if you were there.

TIP

Compared with traditional NAT traversal setups, Surge Ponte needs no extra server, is far simpler to configure, and encrypts everything end to end.

Server Types#

Surge Mac and Surge on Apple TV can act as either the server or a client; iOS devices are client-only.

When setting up the server side, there are three connection methods to choose from:

TypeBest forNotes
Direct NAT traversalFull Cone NAT networksDepends on your router and ISP; usually not something you can change
Proxied NAT traversalAny networkRequires a proxy that supports UDP forwarding; consumes proxy traffic
Static port forwardingYou have a public IPNeeds a port mapping on your router; for advanced users

Use Cases#

  • Accessing your home NAS or IP cameras while traveling
  • Remotely debugging smart home devices
  • Routing your traffic through your home network’s proxy rules

Prerequisites#

  • A legitimate Surge license (Mac/iOS/tvOS)
  • The server and client signed in to the same iCloud account

Configuration#

Using an Apple TV as the Ponte server:

1. Pick a connection type#

On the Apple TV inside your home network, open Surge, go to the Ponte settings, and choose the connection type that fits your network.

I went with static port forwarding, which required opening UDP port 6208 on my router — see the port forwarding guide for details.

2. Name the device#

Give the Ponte server an easy-to-recognize name, e.g. HOMETV.

3. Add a proxy rule#

In the client’s Surge configuration, add a rule that sends your home subnet’s traffic through the Ponte device:

surge.conf
[Rule]
# Route requests for the 192.168.2.0/24 subnet through the Ponte device
IP-CIDR,192.168.2.0/24,DEVICE:HOMETV
NOTE

Replace 192.168.2.0/24 with your actual home subnet, and HOMETV with the device name you chose.

4. Verify the connection#

Turn off Wi-Fi, switch to cellular, and try reaching a home network resource (e.g. the router admin page at 192.168.2.1) to confirm the Ponte tunnel is up.

Surge Ponte connected

Accessing My Home Network with Surge Ponte
https://www.mihouo.com/en/posts/network/using-surge-proxy-to-access-home-network-via-public-internet/
Author
Jia
Published at
2024-12-27
License
CC BY-NC-SA 4.0